A kitchen sink that drains slowly or smells sour usually has a problem sitting a few inches below the basin. Learning how to clean the p trap under kitchen sink plumbing takes about as long as washing a load of dishes, and it often clears the blockage without any chemicals. If the trap comes out clean and the water still won’t move, the clog is farther down the line, and that’s where our clogged drain service in Downers Grove comes in.
What the P Trap Does
The P trap is the curved section of pipe directly below the sink drain. Its bend holds a small amount of water after every use, and that water forms a seal that keeps sewer gas from coming back up through the drain. The same bend catches food scraps, grease, and the occasional ring before they travel deeper into the drain system.
Because it’s built to catch debris, the trap is also a common place for a kitchen clog to form. Grease cools and sticks to the pipe walls, and food particles collect on it over time. On a double-bowl sink, both sides usually join at a tee fitting above the trap. A garbage disposal drains into that same fitting, so everything that leaves the sink passes through this one bend.
Tools and Prep to Clean a P Trap
You won’t need much for this job:
- A bucket or shallow pan
- Old towels
- Rubber gloves
- Slip-joint pliers or channel locks, only if the nuts won’t turn by hand
- A bottle brush, small wire brush, or old toothbrush
Clear out everything stored in the cabinet so there’s room to work, and lay towels on the cabinet floor. If someone already poured a chemical drain cleaner into the sink, the standing water in the trap may still contain it. Those products are harsh on skin and eyes, so wear gloves and eye protection, or call a plumber instead of opening the trap yourself.
Step by Step: How to Clean the P Trap Under Kitchen Sink Plumbing
1. Position the Bucket
Set the bucket directly under the curved part of the trap. There’s always water sitting in the bend, and a clogged sink may have a lot more backed up above it.
2. Loosen the Slip Nuts
The large nuts at each end of the trap are called slip nuts. Plastic ones usually turn by hand. If they’re stuck, use pliers gently, since plastic nuts and threads can crack under too much force. Once both nuts are loose, lower the trap and let the water drain into the bucket.
3. Empty and Scrub the Trap
Dump the contents into the bucket and look at what came out. Scrub the inside of the trap with a brush until the walls are clean. Rinse it in a bathroom sink or utility tub rather than the kitchen sink you’re working on, because nothing is connected underneath to catch the water.
4. Check the Pipes on Either Side
While the trap is off, look into the tailpiece coming down from the sink and the drain arm going into the wall. A brush will reach a few inches into each one. If water stays standing in the wall pipe after the trap is removed, the blockage is past the trap and cleaning it won’t fix the problem.
5. Inspect the Washers and Reassemble
Each slip nut presses a plastic or rubber washer against the pipe. The washer is what makes the joint watertight, not the threads. If a washer is cracked, flattened, or missing, replace it before the trap goes back on. Line the trap up, thread the nuts on by hand, and snug them down without overtightening.
6. Test for Leaks
Run water for a minute or two and hold a dry paper towel under each joint. A drip at a connection usually means the nut needs a little more tightening or the washer isn’t seated evenly. Running the water also refills the bend, so the seal against sewer gas is back in place.
When a Clean P Trap Doesn’t Solve the Problem
Knowing how to clean the p trap under kitchen sink drains handles a lot of single-sink clogs, but a sink that still drains slowly afterward has a blockage in the branch line inside the wall or farther along. Some homeowners try a hand auger at that point, and our guide to using a plumbing snake explains how to run one without damaging the pipe. If other drains in the house are slow or backing up too, the problem may be in the main line, and the warning signs of a clogged sewer line are worth reviewing before you spend more time under the sink.
Odor is a separate issue. A sink that smells even after the trap is cleaned may have a trap that’s losing its water. When drain lines aren’t vented properly, draining water can pull the water out of the bend and leave nothing to block sewer gas. A sulfur smell from a drain has more than one possible cause, so it helps to pin down the source before choosing a fix.
Keeping Grease Out of the Trap
Fats, oils, and grease are behind a lot of kitchen trap clogs. Grease poured down the drain cools quickly, hardens on the inside of the pipe, and catches the food particles that follow it. Scraping pans into the trash and wiping greasy dishes with a paper towel before washing them keeps most of it out. A sink strainer catches the scraps that would otherwise settle in the bend.
For larger amounts of used cooking oil, the Downers Grove Sanitary District has run a recycling drop-off at its Administration Center on Curtiss Street, where the oil is turned into electricity at the district’s treatment plant. Check the district’s current guidelines before you go, since program details can change.
Help From a Downers Grove Plumber
Plumbing Pros is a family-owned and operated plumbing company that has worked in Downers Grove and the surrounding communities for more than 20 years. The company is OSHA certified, and its work comes with a one-year workmanship warranty. Blocked sewers and flooding are treated as priority calls with 24/7 availability. Financing is available through Wisetack for larger repairs, and military members, first responders, and teachers receive 10% off labor.
If you’ve cleaned the trap and the sink still won’t drain, call Plumbing Pros to schedule a visit.